American-car-craft Ford Raptor Header Plate with Battery Cover & Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture American-car-craft Ford Raptor Header Plate with Battery Cover & . American Car Craft Ford Raptor Header Plate with Battery Cover & Fuse Box Perforated 2010-2013 User Manual [en] Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
AMERICAN CAR CRAFT INSTRUCTIONS
FORD RAPTOR HEADER PLATE/RADIATOR SUPPORT w/BATTERY COVER & FUSE BOX PERFORATED 3pc
PART #773002
Parts Included:
1 -Stainless Header/Radiator Support Cover
1 -Stainless Battery Cover w/Hook Velcro attached
1 -Fuse Box Cover
4- Zip ties
3- Decorative fluid cap covers with Velcro attached
4 -Decorative Chrome caps shaved
4 - Velcro attachment donuts
2 - Wide head Phillips 6/32x1/2 stainless machine screws
2 - Wide head Phillips 6/32x3/4 stainless machine screws
2 - 1” Zink Washer head sheet metal screws
1 - 1” black sheet metal screw
2 ¼ green spacers
3- Sheet metal clip nuts
4- ¼ Stainless flat fender washers
4- Special center tapped 6MMx1” Zink flange style bolts
2- Sheet metal type decorative thumb screws
1- Self stick stainless battery cover bracket with Furry Velcro attached
1-Adhesive promoter pen
Introduction: Your new stainless cover has been designed for the 2011 6.2 Raptor and incorporates a battery cover and
fuse box cover as well as three fluid cap covers. Although the cover has been custom designed for this application you
will need to make preparations to create clearance of the a/c and electrical lines. These procedures are relatively easy to
perform and must be done before you attempt to install your new cover.
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - PART #773002

AMERICAN CAR CRAFT INSTRUCTIONS FORD RAPTOR HEADER PLATE/RADIATOR SUPPORT w/BATTERY COVER & FUSE BOX PERFORATED 3pc PART #773002 Parts Included:

Page 2

Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until the installation is complet

Page 3

smaller screws and snug them down. There is no need to over tighten these just snug will work fine. At this time take a look at the center area to det

Page 4

#5 #6 #7

Commentaires sur ces manuels

Pas de commentaire