American-car-craft Prowler Transmission Cooler Deluxe Cover with Kat Manuel d'utilisateur télécharger pdf

AMERICAN CAR CRAFT INSTRUCTIONS

Prowler High Polished Stainless Steel Transmission Cooler

PART #822037

PARTS INCLUDED:

1-Transmission Cooler Cover

4-3/4” Self tapping washer head screws

2-5/16” x ¾” bolts

2-5/16” flat washers

PROTECTIVE LINER INFORMATION: Your new accessories will come to you with a protective surface liner.

Leave this liner in place until the installation is complete to prevent finger prints and/or possible scratches

during installation.

1. Before you place your new cover into position take a look under the

car to see if your model contains four threaded holes located on the rear

frame rail. These holes would be intended for the factory prowler trailer

hitch option. If your prowler has these four threaded holes your new cover

has been designed to make use of the two outer whole locations.

If your model contains no holes then you will need to pilot them with the

"self-tapping screws".

2. Place your new cover over the transmission cooler so that the cover

will clip over the back of the coolers mounting bracket.

3. Align the cover with the factory holes on the aluminum frame rail and

attach the cover by installing the two 5/16 bolts and washers provided.

Remove the protective liner.

1 2

AMERICAN CAR CRAFT INSTRUCTIONS Prowler High Polished Stainless Steel Transmission Cooler PART #822037 PARTS INCLUDED: 1-Transmission Cooler Cover 4

Page 2

4. If your prowler has no holes in the frame rail then simply pilot the four holes in the mounting tabs to the frame rail using a 9/64

Pas de commentaire

American-car-craft Prowler Transmission Cooler Deluxe Cover with Kat Manuel d'utilisateur