American-car-craft Mustang Doorsill Trim Kit 14Pc Polished 2010-2012 Manuel d'utilisateur télécharger pdf

AMERICAN CAR CRAFT INSTRUCTIONS

2010-2012 Mustang Doorsill Trim Kit 14Pc Polished

Part #271019

GENERAL PART INSTALLATION INSTRUCTIONS

Introduction: In the next few paragraphs we will explain to you what you will need to know and do for a successful

application of ACC Stainless Steel Accessories. It is important to understand that almost all stainless steel peel and stick

accessories need to be pre shaped by hand in order to achieve a nice long term installation. We realize that all parts are

different from each other but as far as the installations of these parts they all will need to follow the same set of general

instructions.

Liner info: Your new accessories will come to you with a protective surface liner. Leave this liner in place until the

installation is complete to prevent finger prints and or possible scratches during installation. This liner is required to

remain on the part until you are instructed to remove it.

1. The first thing that needs to be done in any peel and stick application is surface preparation. It is important

that you examine the surface to determine if any kind of special treatments have ever been used. Such as wax/silicone

treatments and/or polymer surface preps. Take a strip of masking tape and press it very firmly to make it adhere to the

surface. Then peel it off to see how difficult it is to remove. If your masking tape is removed extremely easy and/or does

not stick at all then you will need to perform a special surface preparation. In most cases like this you will need to make

a solution of a straight detergent (Johnson’s Baby Shampoo or Palmolive Dish Soap) and water. Mix a 32oz bottle with

about five table spoons of soap detergent. Once you have the solution made wash the surface scrubbing quite

vigorously to remove any surface contaminates.

When this is done you can proceed to the regular preparation. This is done by scrubbing the surface with alcohol and

wiping it dry. At this point you will need to test the surface again to see if you have achieved a tack. Apply a new strip of

masking tape to the surface. If it adheres you have done a good job, if it doesn’t then you must perform the wash again

1 2

Part #271019 1

Résumé du contenu

Page 1 - Part #271019

AMERICAN CAR CRAFT INSTRUCTIONS 2010-2012 Mustang Doorsill Trim Kit 14Pc Polished Part #271019 GENERAL PART INSTALLATION INSTRUCTIONS Introduction:

Page 2

and again if necessary until you have achieved a nice tack. Once a tack has been achieved swipe the entire surface to be mounted with the adhesive pro

Commentaires sur ces manuels

Pas de commentaire

American-car-craft Mustang Doorsill Trim Kit 14Pc Polished 2010-2012 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture American-car-craft Mustang Doorsill Trim Kit 14Pc Polished 2010-2012. American Car Craft Mustang Doorsill Trim Kit 14Pc Polished 2010-2012 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture American-car-craft Mustang Doorsill Trim Kit 14Pc Polished 2010-2012