American-car-craft Mustang Master Cylinder Cover Polished w_Cap V8 &a Manuel d'utilisateur télécharger pdf

AMERICAN CAR CRAFT INSTRUCTIONS

MUSTANG GT 5.0 2011-2012 MASTER CYLINDER COVER w/PERFORATED CAP

PART #273016patent pending

Parts Included:

1-Stainless Master Cylinder Cover

1-Perforated Cap Cover

1-Adhesive Promoter Pack

Introduction: This new ACC design is a truly custom look for the new mustang. It will require very little

preparation and should take just a few minutes to install.

Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in

place until the installation is complete to prevent finger prints and or possible scratches during installation.

1. Peel the protective liner from the body of your new stainless cover.

2. Remove the factory master cylinder cap and then set the new cover in place over the factory

reservoir. Then replace the factory cap.

1 2

AMERICAN CAR CRAFT INSTRUCTIONS MUSTANG GT 5.0 2011-2012 MASTER CYLINDER COVER w/PERFORATED CAP PART #273016patent pending Parts Included: 1-Stainle

Page 2

3. Scrub clean the top of the factory cap with alcohol to remove any dirt then swipe the cap with the adhesive promoter provided. This chemical is

Pas de commentaire

American-car-craft Mustang Master Cylinder Cover Polished w_Cap V8 &a Manuel d'utilisateur