American-car-craft Ford Raptor Taillight Carbon Fiber Wrap 2Pc 2010-2 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture American-car-craft Ford Raptor Taillight Carbon Fiber Wrap 2Pc 2010-2. American Car Craft Ford Raptor Taillight Carbon Fiber Wrap 2Pc 2010-2013 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
AMERICAN CAR CRAFT INSTRUCTIONS
Raptor Carbon Fiber Taillight Wraps
PART #772004
Parts Included:
2-Carbon Fiber Wraps
1-Adhesive Promoter Pack
1-Felt Squeegee
Introduction: This unique graphic will enhance the body styling of your Raptor with a quality carbon fiber look that is
easy to install and offer a nice custom look
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until
the installation is complete to prevent finger prints and or possible scratches during installation.
1. Thoroughly scrub clean the areas of the Raptor body with alcohol to remove any and all wax and dirt.
2. Test that you have done a good job at this by applying ordinary masking tape to a few areas to see if that tape
sticks well. If there is any waxes left the tape will not adhere. If this happens, simply re- clean the area until you
achieve a tack.
3. You have been supplied with and adhesive promoter applicator. This promoter is to be applied to the very rim of
the body line ONLY! This will insure that your new graphic will permanently bond to the paint long term. Do NOT
apply this chemical to the entire body of the graphic area.
4. Now that you have successful prepared your Raptor to receive the graphic place each section into their
appropriate spot to get yourself acquainted with just how they are intended to fit. Draw a cross hair along the
Vue de la page 0
1 2

Résumé du contenu

Page 1 - PART #772004

AMERICAN CAR CRAFT INSTRUCTIONS Raptor Carbon Fiber Taillight Wraps PART #772004 Parts Included: 2-Carbon Fiber Wraps 1-Adhesive Promoter Pack 1-Fel

Page 2

edge of the graphic with a pencil for exact placement. This is important because we will recommend that the graphic be put on dry for the best results

Commentaires sur ces manuels

Pas de commentaire