AMERICAN CAR CRAFT INSTRUCTION
C5 FRONT PERFORATED LIT NOSE CAP
PART# 033055patent pending
PARTS INCLUDED:
1-STAINLESS STEEL NOSE CAP
1-COUNTER SINK BIT
6-STAINLESS FLAT HEAD SCREWS
1-ADHESIVE PROMOTER PACK
1. Remove the six bolts holding the top of the urethane bumper MAKE NOTE of
where any U-shaped body spacers are placed at this area and remove (set aside)
NOTE: Not all cars will have these. Then remove the body clip nuts just under
the urethane bumper.
2. Mark a dot 1/4 inch in front of the newly exposed holes (towards the front of the
car) in the urethane bumper and drill a 1/8 inch hole thru the bumper at these dots
and down thru the actual bumper tab just underneath.
3. Using the counter sink (provided) bore the 1/8 inch holes set in the urethane
bumper ONLY. Be careful to bore all six holes just large enough to allow the six
stainless flat head screws (provided) to fit flush.
Commentaires sur ces manuels