American-car-craft Challenger_Charger_Magnum_300 SRT 8 5.7L_6.4L MOPA Manuel d'utilisateur télécharger pdf

AMERICAN CAR CRAFT INSTRUCTIONS

CHALLENGER SRT 8/5.7 MOPAR COLD AIR BOX FILTER CUSTOM TOP PLATE

PART #153030

PARTS INCLUDED:

1-Plastic Cover w/Velcro

1-Small Scratch Pad

1-Adhesive Promoter Pack

1-32.5” Length Of Furry Velcro

1-Large 1.25 Washer Head Type Bolt, Nut and Washer

1-Decorative Chrome Cap w/Butyl Putty

INTORDUCTION: This new accessory is a unique and stylish part designed to add an awesome custom look to what

otherwise would be a relatively unattractive air filter box. Please note that the cover is strictly decorative and is not

intended to seal the factory air box.

PROTECTIVE LINER INFORMATION: Your new accessories will come to you with a protective surface liner. Leave this

liner in place until the installation is complete to prevent finger prints and/or possible scratches during installation.

1. The first step for this installation will be to prepare the air box to receive the new accessory by removing the

rubber gasket attached to the air box top ridge. (Note: This gasket will not be reused).

2. You will notice that the air box is fastened to the vehicle with one single bolt located at the top front area of

the box and that this bolt has been sleeved with a steel sleeve encapsulated with a rubber grommet. Remove

this bolt. Then remove the rubber grommet from the air box. (Note: This grommet will not be reused).

1 2 3 4

AMERICAN CAR CRAFT INSTRUCTIONS CHALLENGER SRT 8/5.7 MOPAR COLD AIR BOX FILTER CUSTOM TOP PLATE PART #153030 PARTS INCLUDED: 1-Plastic Cover w/Velcro

Page 2

3. Lift the plastic box out of its valley in the engine bay just enough to allow you to see the rubber grommet or grommets that the plastic box seat

Page 3

5 7. Once these procedures are complete, you can now set up the top ridge for the new cover. You have been provided with a small piece of scratch p

Page 4

7 9. Now you are ready to install your new cover. You will notice that your new cover has Velcro attached to the underside of the covers frame and

Pas de commentaire

American-car-craft Challenger_Charger_Magnum_300 SRT 8 5.7L_6.4L MOPA Manuel d'utilisateur