American-car-craft Camaro Shock Tower Dome Kit Polished Stand Alone 3 Manuel d'utilisateur télécharger pdf

AMERICAN CAR CRAFT INSTRUCTIONS

CAMARO SHOCK TOWER DOMES 3pc 2013

PART #103061

PARTS INCLUDED:

2-Chrome Domes

1-Stainless Shell

10-Velcro Cookies

1-Adhesive Promoter Pack

Introduction: These new dome covers are a great way to cover and customize the top of the Camaro shock towers

should you elect to not use the factory strut support provided for on the new towers. The new dome is designed to cap

off the exposed and unsightly threaded whole platform.

Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until

the installation is complete to prevent finger prints and or possible scratches during installation.

1. The first step will be to remove the factor hood support strut and set it up in such a way as to still support the

hood so you can work under the hood but without the strut in your way. Positioning it at the nose area will work

best. Then remove the strut stud. NOTE: It is important to know the strut stud removes from the right side of

the bracket and the nut on the left side of the bracket is permanently welded and cannot be removed. Once the

stud has been removed place the stainless shells provided in your kit over the stud hole and then replace the

stud and snug it down. This shell is provided to finish the opening in the main dome hole.

1 2

AMERICAN CAR CRAFT INSTRUCTIONS CAMARO SHOCK TOWER DOMES 3pc 2013 PART #103061 PARTS INCLUDED: 2-Chrome Domes 1-Stainless Shell 10-Velcro Cookies 1

Page 2

2. You will notice the large wire harness attached between the passenger side shock tower and fender. Detach this harness by pulling it up rele

Pas de commentaire

American-car-craft Camaro Shock Tower Dome Kit Polished Stand Alone 3 Manuel d'utilisateur