American-car-craft Camaro Fuel Rail Covers Perforated "SS Style Manuel d'utilisateur télécharger pdf

AMERICAN CAR CRAFT INSTRUCTIONS

Camaro Replacement Fuel Rail Covers

Camaro Plenum Cover

PART #103038 or #103037 Illuminated

PART #103035 or #103034 Illuminated

Parts Included:

4-Washer Head Style ¼ 20 Elevator Bolts

4-Small Stainless Flat Washer Spacers

4-Yellow Spacers

4-1/4 20 Clip Nuts

1-36”' Wire w/3 pigtail plugs and one 7 amp fuse holder (optional lighted version only)

Introduction: These new accessories are designed to fit the 2010-2012 Camaro LS3 engine. The accessories

require you to perform our wire tuck instructions before you attempt to install these parts. SEE BELOW

Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in

place until the installation is complete to prevent finger prints and or possible scratches during installation.

1 2 3 4

Page 1

AMERICAN CAR CRAFT INSTRUCTIONS Camaro Replacement Fuel Rail Covers Camaro Plenum Cover PART #103038 or #103037 Illuminated PART #103035 or #103034

Page 2

1. You will notice two exposed holes directly on the fuel rails. These two holes will be fitted with a special washer head bolt and

Page 3

2. Now that the engine is uncovered take a minute to look over the engine to identify the areas we will rearrange. You will notice the two heater hos

Page 4

9. Next remove the plastic engine cover retainer by removing the single 10mm bolt securing the one end. Once removed lift the bracket off the fuel li

Plus de documents pour Pour la voiture American-car-craft Camaro Fuel Rail Covers Perforated "SS Style

Pas de commentaire